This command sets or displays the hypervisor settings for the system. This command does not enable or disable the hypervisor ...

This command sets or displays the hypervisor settings for the system.  This command does not enable or disable the hypervisor debugger for any particular OS loader entry. To enable or disable the hypervisor debugger for a particular OS loader entry, use "bcdedit /set  HYPERVISORDEBUG ON". For information about identifiers, run "bcdedit /? ID".  To set an individual hypervisor debugger setting, use "bcdedit /set {hypervisorsettings}  ".  For information about valid types, run "bcdedit /? TYPES".  bcdedit /hypervisorsettings [  [DEBUGPORT:] [BAUDRATE:]                               [CHANNEL:] ]           Specifies the type of debugger.  can be one of                     SERIAL or 1394.                For SERIAL debugging, specifies the serial port to use as                     the debugging port.                For SERIAL debugging, specifies the baud rate to be used                     for debugging.             For 1394 debugging, specifies the 1394 channel to be used                     for debugging.  Examples:  The following command displays the current hypervisor settings:      bcdedit /hypervisorsettings  The following command sets the hypervisor debugger settings to serial debugging over COM1 at 115,200 baud:      bcdedit /hypervisorsettings SERIAL DEBUGPORT:1 BAUDRATE:115200  The following command sets the hypervisor debugger settings to 1394 debugging using channel 23:      bcdedit /hypervisorsettings 1394 CHANNEL:23