This command sets the one-time boot sequence to be used by the boot manager. bcdedit /bootsequence[...] [ /addfirst | /addlast | /remove ] [...] Specifies a list of identifiers that make up the boot sequence. You must specify at least one identifier and must separate identifiers by spaces. For more information about identifiers, run "bcdedit /? ID". /addfirst Adds the specified entry identifier to the top of the boot sequence. If this switch is specified, only a single identifier may be specified. If the identifier is already in the list, it is moved to the top of the list. /addlast Adds the specified entry identifier to the end of the boot sequence. If this switch is specified, only a single identifier may be specified. If the identifier is already in the list, it is moved to the end of the list. /remove Removes the specified entry identifier from the boot sequence. If this switch is specified, only a single entry identifier may be specified. If the identifier is not in the list then the operation has no effect. If the last entry is being removed, then the boot sequence value is deleted from the boot manager entry. Examples: The following command sets two OS entries and the NTLDR based OS loader in the boot manager one-shot boot sequence: bcdedit /bootsequence {802d5e32-0784-11da-bd33-000476eba25f} {cbd971bf-b7b8-4885-951a-fa03044f5d71} {ntldr} The following command adds the specified OS entry to the end of the boot manager one-shot boot sequence: bcdedit /bootsequence {802d5e32-0784-11da-bd33-000476eba25f} /addlast
This command sets or displays the hypervisor settings for the system. This command does not enable or disable the hypervisor ...
This command sets the default entry that the boot manager will use when the timeout expires. bcdedit /default Specifies the ...
This command sets the display order to be used by the boot manager. bcdedit /displayorder . /addfirst | /addlast | /remove ...
This command sets the global Emergency Management Services settings for the system. Emssettings does not enable or disable ...
This command sets the one-time boot sequence to be used by the boot manager. bcdedit /bootsequence . /addfirst | /addlast ...
This command sets the reference to the owner authorization that the TPM uses when executing an OIAP or OSAP session. Use ...
This command sets the time to wait, in seconds, before the boot manager selects a default entry. For information about setting ...
This command starts the process of calculating a SHA-1 digest. This command must be followed by execution of TPM_SHA1Update ...
This command takes ownership of the TPM with a new owner authorization value, derived from the owner password. Among other ...