The Network Access Permission setting in the dial-in properties of the user account in Active Directory is set to Deny access to the user. To change the Network Access Permission setting to either Allow access or Control access through NPS Network Policy, obtain the properties of the user account in Active Directory Users and Computers, click the Dial-in tab, and change Network Access Permission.
The Netlogon service failed to register the service with the service controller. The service was terminated. The following ...
The NetLogon service on this domain controller has been configured to use port %1 for incoming RPC connections over TCP/IP ...
The network %1 ran out of network control blocks (NCBs). You may need to increase NCBs for this network. The following information ...
The network access method used by the access client to connect to the network does not match the value of the NAS-Port-Type ...
The Network Access Permission setting in the dial-in properties of the user account in Active Directory is set to Deny access ...
The Network Access Protection (NAP) enforcement client could not create system resources for remote access connections. Some ...
The Network Access Protection (NAP) enforcement client could not start PPP renegotiation on the following remote access connection: ...
The Network Access Protection (NAP) enforcement client did not respond. Some network services or resources might not be available. ...
The Network Access Protection (NAP) enforcement client failed to register with the Network Access Protection Agent (NAPAgent) ...