The base unit of the values returned by this Sensor. All the values returned by this Sensor are represented in the units obtained by (BaseUnits * 10 raised to the power of the UnitModifier). For example, if BaseUnits is Volts and the UnitModifier is -6, then the units of the values returned are MicroVolts. However, if the RateUnits property is set to a value other than \"None\", then the units are further qualified as rate units. In the above example, if RateUnits is set to \"Per Second\", then the values returned by the Sensor are in MicroVolts/Second. The units apply to all numeric properties of the Sensor, unless explicitly overridden by the Units qualifier.
The BadPasswordCount property indicates the number of times the user enters a bad password when logging on to a Win32 system. ...
The Base Application Partition has been marked changes disabled. Partitions are not currently visible. Partitions can be ...
The Base Filtering Engine (BFE) is a service that manages firewall and Internet Protocol security (IPsec) policies and implements ...
The base schema was not set. You may have problems importing the generated LDIF file because it may contain definitions of ...
The base unit of the values returned by this Sensor. All the values returned by this Sensor are represented in the units ...
The basic constraints extension is used to indicate whether the certificate is a CA certificate or an end entity certificate. ...
The BatteryRechargeTime property indicates the time required to fully charge the battery. The BatteryRechargeTime property ...
The BaudRate property indicates the baud (bits per second) rate at which the communications device operates. Example: 9600 ...
The beginning address, referenced by an application or operating system and mapped by a memory controller, for this memory ...