For each zone, the Network Protocol Lockdown security restriction may be configured to prevent active content obtained through ...

For each zone, the Network Protocol Lockdown security restriction may be configured to prevent active content obtained through restricted protocols from running in an unsafe manner, either by prompting the user, or simply disabling the content. For each zone, this list of protocols may be configured here, and applies to all processes which have opted in to the security restriction.

If you enable this policy setting for a zone, this sets the list of protocols to be restricted if that zone is set to Prompt or Disable for "Allow active content over restricted protocols to access my computer."

If you disable or do not configure this policy setting for a zone, no protocols are restricted for that zone, regardless of the setting for "Allow active content over restricted protocols to access my computer."

Note.  If policy for a zone is set in both Computer Configuration and User Configuration, both lists of protocols will be restricted for that zone.

For directory paths, indicates if the operation is to apply to the entire directory tree or only to the directory entry itself. ... For each selected item, Windows will check for problems and send you a message if problems are found. How does Security and ... For each selected item, Windows will check for problems and send you a message if problems are found. How does Security and ... For each zone, the Binary and Scripted Behavior security restrictions may be configured to allow only a list of admin-approved ... For each zone, the Network Protocol Lockdown security restriction may be configured to prevent active content obtained through ... For element with Id %1!u!( 1!x!), under '%2', attribute 'aggregate' is not allowed since the parent counterSet has either ... For element with Id %1!u!( 1!x!), under '%2', attribute 'baseID' is required. Here is the list of counter types that require ... For element with Id %1!u!( 1!x!), under '%2', attribute 'multiCounterID' is required, and the counter referenced by that ... For element with Id %1!u!( 1!x!), under '%2', attributes 'perfTimeID' and 'perfFreqID' are required, and the counters referenced ...