IPSec user mode security association establishment failed. Keying module type: AuthIp Local address: %1 Remote address: %2 ...

IPSec user mode security association establishment failed.

Keying module type: AuthIp

Local address: %1

Remote address: %2

Local port: %3

Remote port: %4

Peer private address: %5

User mode authentication method: %6

User mode my Id: %7

User mode peer Id: %8

Failure point: %9

Failure reason: %10

User mode IKE state: %11

Initiator or Responder: %12

User mode impersonation: %13

IPSec quick mode security association establishment failed. Keying module type: %1 Local address: %2 Local address mask: ... IPsec Quick Mode This policy setting allows you to audit events generated by Internet Key Exchange protocol (IKE) and Authenticated ... IPsec received a packet from a remote computer with an incorrect Security Parameter Index (SPI). This is usually caused by ... IPSec received inbound clear text packet that should have been secured: Packet Source: %1 Inbound SA: %2 Number of Packets: ... IPSec user mode security association establishment failed. Keying module type: AuthIp Local address: %1 Remote address: %2 ... IPSec user mode security association establishment failed. Keying module type: AuthIp Local address: %1 Remote address: %2 ... IPsec will use these settings to establish secured connections when there are active connection security rules. When you ... IPv4 support has been disabled in WMPNetworkSvc because IP address table retrieval encountered error '%1'. To enable IPv4 ... IPv4 support has been disabled in WMPNetworkSvc because NotifyAddrChange encountered error '%1'. To enable IPv4 support, ...