IPSec driver is starting in Stateful mode. IPSec stateful filtering is being applied while this computer starts up. During this time, only responses to connections initiated by this computer are permitted, unless you have configured additional traffic exemptions by using the bootexemptions command. This command is available through the Netsh IPSec command-line tool. For information about how to use this command to exempt traffic from IPSec filtering during computer startup, at the command prompt, type "netsh ipsec dynamic set config /?"
IPRIPv2 was unable to initialize a table to hold information about neighboring IPRIP routers. The data is the error code. ...
IPRIPv2 was unable to receive an incoming message on the local interface with IP address %1. The data is the error code. ...
IPRIPv2 was unable to request notification of events on the socket for the local interface with IP address %1. The data is ...
IPRIPv2 was unable to send a packet from the interface with IP address %1 to the IP address %2. The data is the error code. ...
IPSec driver is starting in Stateful mode. IPSec stateful filtering is being applied while this computer starts up. During ...
IPSec inbound packet integrity check failed: Packet Source: %1 Inbound SA: %2 Number Of Packets: %3 Received packet from ...
IPSec inbound packet replay check failed, inbound packet had too low a sequence number to ensure it was not a replay: Packet ...
IPSec inbound packet replay check failed, inbound packet had too low a sequence number to ensure it was not a replay: Packet ...
IPSec inbound packet replay check failed: Packet Source: %1 Inbound SA: %2 Number of Packets: %3 Received packet from over ...