Disable new traffic handling on all remoted-control-enabled nodes, for the rule containing the specified port on specified nodes. Port may take any value from 0 to 65,535 or 0xFFFFFFFF to specify all ports. NumNodes returns the number of nodes that have responded to the request. This method is deprecated and no longer in use. You must connect to each node individually and use the corresponding method on the MicrosoftNLB_Node class.
Disable cursor and bitmap accelerations. Use this setting to correct problems with the mouse pointer, or to correct problems ...
Disable IPv6 over all non-tunnel interfaces, including LAN interfaces and Point-to-Point Protocol (PPP)-based interfaces. ...
Disable new traffic handling for rule containing the specified port.Port may take any value from 0 to 65,535 or 0xFFFFFFFF ...
Disable new traffic handling for rule containing the specified virtual IP address and port. The values of virtual Ip address ...
Disable new traffic handling on all remoted-control-enabled nodes, for the rule containing the specified port on specified ...
Disable recursion (also disables forwarders) BIND secondaries Fail on load if bad zone data Enable round robin Enable netmask ...
Disable tracing for "Default Web Site/" for requests to *.aspx, removing any trace configuration that is defined at the specified ...
Disabled performance counter data collection for this session from the "%1!s!" service because the performance counter library ...
Disabled performance counter data collection from the "%1!s!" service because the performance counter library for that service ...