Direct replication could not occur between the following source and destination domain controllers because an unsupported intersite transport is configured for the following Connection object. The Connection object representing intersite replication from the source domain controller to the destination domain controller indicates that the writeable directory partition should be replicated over the intersite transport. Connection object: %1 Directory partition: %4 Source domain controller: %2 Destination domain controller: %3 Intersite transport: %5 Domain controllers in the same domain, but in different sites are required to use the IP transport for replication. Only domain controllers in different domains can replicate using other transports.
Digital TV Signal Setup. Configure over-the-air Digital TV, including high-definition TV, which may be available in your ...
DirecPC 3.0 has a known compatibility issue with this version of Windows and might not run as expected. The QoS Packet Scheduler ...
Direct dump configuration failed. Validate the filename and make sure the target device is not a Fault Tolerant set member, ...
Direct read found corrupted page %4 with error %5. If this error persists, please restore the database from a previous backup. ...
Direct replication could not occur between the following source and destination domain controllers because an unsupported ...
Direct3D 9.0 is needed to run this screen saver, but can't be found. Please install the latest version of DirectX and try ...
DirectCD 2 has a known compatibility issue with this version of Windows and might not run as expected. Drivers installed ...
DirectCD 3 has a known compatibility issue with this version of Windows and might not run as expected. Drivers installed ...
DirectDraw Blt and Lock calls may encounter device busy situations more frequently on Windows XP than was common on Windows ...