For each zone, the Binary and Scripted Behavior security restrictions may be configured to allow only a list of admin-approved ...

For each zone, the Binary and Scripted Behavior security restrictions may be configured to allow only a list of admin-approved behaviors. This list may be configured here, and applies to all processes which have opted in to the behavior, and to all zones. (Behaviors are components that encapsulate specific functionality or behavior on a page.)

If you enable this policy setting, this sets the list of behaviors permitted in each zone for which Script and Binary Behaviors is set to 'admin-approved'. Behaviors must be entered in #package#behavior notation, e.g., #default#vml.

If you disable this policy setting, no behaviors will be allowed in zones set to 'admin-approved', just as if those zones were set to 'disable'.

If you do not configure this policy setting, only VML will be allowed in zones set to 'admin-approved'.

Note.  If this policy is set in both Computer Configuration and User Configuration, both lists of behaviors will be allowed as appropriate.

For CounterSet '%1', bad nameID %2!u!( 2!x!) was specified. nameID attribute is required, and must be globally unique. In ... For directory paths, indicates if the operation is to apply to the entire directory tree or only to the directory entry itself. ... For each selected item, Windows will check for problems and send you a message if problems are found. How does Security and ... For each selected item, Windows will check for problems and send you a message if problems are found. How does Security and ... For each zone, the Binary and Scripted Behavior security restrictions may be configured to allow only a list of admin-approved ... For each zone, the Network Protocol Lockdown security restriction may be configured to prevent active content obtained through ... For element with Id %1!u!( 1!x!), under '%2', attribute 'aggregate' is not allowed since the parent counterSet has either ... For element with Id %1!u!( 1!x!), under '%2', attribute 'baseID' is required. Here is the list of counter types that require ... For element with Id %1!u!( 1!x!), under '%2', attribute 'multiCounterID' is required, and the counter referenced by that ...