This property specifies whether or not a multicast MAC address should be used for cluster operations. If this option is enabled, Network Load Balancing converts the cluster MAC address belonging to the cluster adapter into a multicast address. It also ensures that the cluster's primary IP address resolves to this multicast address as part of the ARP protocol. At the same time, the adapter can now use its original, built-in MAC address, which, in unicast mode, was disabled.
This property specifies the UDP port that is used to receive remote control commands. By default, these are ports 1717 and ...
This property specifies this host's unique IP address used for network traffic not associated with the cluster (for example, ...
This property specifies this host's unique IP address used for network traffic not associated with the cluster (for example, ...
This property specifies whether identity heartbeats are transmitted. It is on by default. This property is deprecated and ...
This property specifies whether or not a multicast MAC address should be used for cluster operations. If this option is enabled, ...
This property specifies whether remote-control operations are enabled. When disabled, the Service methods will not functionfor ...
This query can only be edited manually. Either it was not created using the controls on the Filter tab, or it has been edited ...
This query cannot be completed because it requires information that is not supported by the domain that is currently targeted. ...
This quorum configuration can be changed using the Configure Cluster Quorum wizard. This wizard can be started from the Failover ...