1. Ensure that the NAT64 server can be reached on the corporate network. 2. Ensure that NAT64 is enabled on the server. 3. If you have native IPv6 connectivity, ensure that the NAT64/DNS64 prefix is configured in the DirectAccess settings. 4. In the Remote Access Server Setup Wizard, ensure that the default NRPT entry points to the internal address of the NAT64/DNS64 server.
Ensure that the configured CAU plug-in is installed on all cluster nodes by following the installation procedure for the ...
Ensure that the DNS Client service on the server is configured to register the appropriate host (A/AAAA) resource records ...
Ensure that the DNS Client service on this domain controller is configured and able to register valid host resource records ...
Ensure that the manufacturer's disk is properly inserted in the drive selected below, or provide the location where the file ...
Ensure that the NAT64 server can be reached on the corporate network. 2. Ensure that NAT64 is enabled on the server. 3. If ...
Ensure that the partition you are about to make active includes valid system files. Otherwise the disk will not start. Do ...
Ensure that the RD Gateway server is a member of an Active Directory domain and that there is network connectivity between ...
Ensure that the same set of CAU plug-ins is installed on all cluster nodes by following the installation procedure for the ...
Ensure that the same version of the DFS Replication service is installed on both machines, including any service packs, downloads ...