The replica source %1:%2 requires Kerberos authentication but does not have a properly registered service principal name (SPN). An partition administrator can register the SPNs for the replica source by running the batch file that is in the data folder of the replica source. Alternatively, you can configure Kerberos authentication as optional; change the value of the attribute msDS-ReplAuthenticationMode from ADAM_REPL_AUTHENTICATION_MODE_MUTUAL_AUTH_REQUIRED to ADAM_REPL_AUTHENTICATION_MODE_NEGOTIATE on the Configuration partition of all instances in the configuration set. When msDS-ReplAuthenticationMode is set to ADAM_REPL_AUTHENTICATION_MODE_NEGOTIATE, replica partners can use NTLM for authentication if Kerberos is not available.
The RenewDHCPLease method renews the IP address on specific DHCP-enabled network adapters. The lease for the IP address assigned ...
The RenewDHCPLeaseAll method renews the IP addresses on all DHCP-enabled network adapters. The lease for the IP address assigned ...
The reparse point %s was found. This folder will not be copied to the installation image. It is suggested that you write ...
The replica source %1:%2 requires Kerberos authentication but does not have a properly registered service principal name ...
The replica source %1:%2 requires Kerberos authentication but does not have a properly registered service principal name ...
The replica/child install failed to get the objectVersion attribute on the schema container on the source DC. Either the ...
The replica/child install failed to read the objectVersion attribute in the SCHEMA section of the file schema.ini in the ...
The replicated folder at local path %2 has been disabled. The replicated folder will not participate in replication until ...
The replicated folder at local path %2!S! has been disabled. The replicated folder will not participate in replication until ...