IPv4 support has been disabled in WMPNetworkSvc because IP address table retrieval encountered error '%1'. To enable IPv4 support, restart the WMPNetworkSvc service.
IPSec received inbound clear text packet that should have been secured: Packet Source: %1 Inbound SA: %2 Number of Packets: ...
IPSec user mode security association establishment failed. Keying module type: AuthIp Local address: %1 Remote address: %2 ...
IPSec user mode security association establishment failed. Keying module type: AuthIp Local address: %1 Remote address: %2 ...
IPsec will use these settings to establish secured connections when there are active connection security rules. When you ...
IPv4 support has been disabled in WMPNetworkSvc because IP address table retrieval encountered error '%1'. To enable IPv4 ...
IPv4 support has been disabled in WMPNetworkSvc because NotifyAddrChange encountered error '%1'. To enable IPv4 support, ...
IRQ trigger level indicating whether the interrupt is triggered by the hardware signal going high (value=4) or low (value=3). ...
IRQ trigger type indicating whether edge (value=4) or level triggered (value=3) interrupts occur. Also, \"Other\" (1) and ...
is a 16-bit application. You do not have permissions to execute 16-bit applications. Check your permissions with your system ...