1. Verify that NAT64 is enabled on the server. 2. For native IPv6 connectivity, verify that the NAT64/DNS64 prefix is configured in the DirectAccess settings. 3. In the Remote Access Server Setup Wizard, ensure that the default NRPT entry points to the internal address of the NAT64/DNS64 server.
Verification of the trust between the domain %2 and the domain %3 was unsuccessful because: %1 To repair a trust to a pre-Windows ...
Verification operation failed. Subject: Security ID: %1 Account Name: %2 Account Domain: %3 Logon ID: %4 Cryptographic Parameters: ...
Verifies that each received packet that is supposed to arrive over a transport mode security association arrives securely. ...
Verify network connectivity to DNS servers. 2. Ensure DNS servers are online and responding to name resolution requests. ...
Verify that NAT64 is enabled on the server. 2. For native IPv6 connectivity, verify that the NAT64/DNS64 prefix is configured ...
Verify that the AD RMS cluster name exists and that AD RMS is operating correctly. If the AD RMS service account is not valid ...
Verify that the assigned IPv6 prefix is not used as a subnet in the corporate network and does not overlap with prefixes ...
Verify that the batteries in the remote control are charged, then hold the remote control directly in front of the remote ...
Verify that the cluster management tools have been installed as part of Remote Server Administration Tools, and then try ...