The network adapter cannot be used by the cluster because it does not contain any valid TCP/IP configurations. Ensure that this network adapter is properly configured and connected to the network. Once the network adapter is properly configured and connected, the cluster will use it automatically.
The network %1 ran out of network control blocks (NCBs). You may need to increase NCBs for this network. The following information ...
The network access translator can automatically assign IP addresses to computers on the private network by using Dynamic ...
The network adapter "%1!ws!" is enabled for DHCP, which is not supported or recommended. Making this node a member of a cluster ...
The network adapter "%1!ws!", which has the connection name "%2!ws!", is on the same network as another network adapter and ...
The network adapter cannot be used by the cluster because it does not contain any valid TCP/IP configurations. Ensure that ...
The network adapter cannot be used by the cluster because it is not configured to use TCP/IP. Ensure that this network adapter ...
The network adapters shown cannot be managed by the cluster. Please ensure that they have valid TCP/IP configurations and ...
The Network Address Translator (NAT) was unable to allocate %1 bytes. This may indicate that the system is low on virtual ...
The Network Address Translator (NAT) was unable to expand the wildcard mappings. This may indicate misconfiguration, insufficient ...