Specifies the amount of time for Automatic Updates to wait, following system startup, before proceeding with a scheduled ...

Windows Server 2003

"Specifies the amount of time for Automatic Updates to wait, following system startup, before proceeding with a scheduled installation that was missed previously. 

If the status is set to Enabled, a scheduled installation that did not take place earlier will occur the specified number of minutes after the computer is next started. 

If the status is set to Disabled or Not Configured, a missed scheduled installation will occur with the next scheduled installation. 

Note: This policy applies only when Automatic Updates is configured to perform scheduled installations of updates. If the "Configure Automatic Updates" policy is disabled, this policy has no effect."

Specifies the active process limit for the job. If you try to associate a process with a job, and this causes the active ... Specifies the additional time for the computer to wait for the domain controller's (DC) response when logging on to the network. ... Specifies the address of the last memory error. The type of error is described by the ErrorInfo property. If the ErrorInfo ... Specifies the amount of time (in seconds) the DC locator remembers that a domain controller (DC) could not be found in a ... Specifies the amount of time for Automatic Updates to wait, following system startup, before proceeding with a scheduled ... Specifies the async control character map that the Ascend PPP implementation must use during the PPP session (Ascend NAS ... Specifies the Audit Permissions for failure. The permissions are a combination of one or more of the following:WINSTATION_QUERY, ... Specifies the Audit Permissions for success. The permissions are a combination of one or more of the following:WINSTATION_QUERY, ... Specifies the category of programs that appears when users open the "Add New Programs" page. If you enable this setting, ...