The default authentication level for Component Services is currently set to None. It is recommended that you change this setting to Connect. To change the default authentication level, click Start, point to Administrative Tools, and then click Component Services. In the Component Services snap-in hierarchy pane, expand Component Services, expand Computers, right-click My Computer, and then click Properties. In the Properties dialog box, on the Default Properties tab, change the default authentication level to Connect.
The decode rectangle height/width must either be both zero or both greater than zero and less than or equal to the size of ...
The dedicated subnet mask is required. Network Load Balancing has automatically generated a subnet mask. If you do not want ...
The default "Anybody" IP filter could not be found, probably because it was explicitly removed. You can either continue without ...
The default access control list (ACL) on the following Domain-DNS object class has been previously removed. All subsequently ...
The default authentication level for Component Services is currently set to None. It is recommended that you change this ...
The default BitLocker Key Derivation Function SP800-56A for ECC smart cards is not supported by your smart card. The Group ...
The default boot program selected is either not a valid boot program file or the file path does not exist. Your clients will ...
The Default Domain Controller Policy was restored successfully Note: Only the contents of the Default Domain Controller Policy ...
The Default Domain Policy was restored successfully Note: Only the contents of the Default Domain Policy was restored. Group ...