s! anontemplate = template simple name authtemplate = template simple name anontemplate

%1!s! 
   [ anontemplate = ] [ template simple name ] 
   [ authtemplate = ] [ template simple name ] 
 
   anontemplate - Specifies the name of the health certificate template to use 
                  when requesting certificates for anonymous health certificate
                  requests. 
 
   authtemplate - Specifies the name of the health certificate template to use 
                  when requesting certificates for authenticated health 
                  certificate requests. 
 
   Note: 
       You can use 'certutil -template' to get a list of available certificate 
       templates. 

       anontemplate and authtemplate must be both set or clear at the same time.

s! - %2!s! is not a valid filter specification. The first IP address specified in the filter must be lower than the second ... s! accept = ENABLE|DISABLE reject = ENABLE|DISABLE Sets event log configuration. accept - accepted authentication (optional). ... s! accounting = ENABLE|DISABLE authentication = ENABLE|DISABLE periodicacctstatus = ENABLE|DISABLE periodicauthstatus = ENABLE|DISABLE ... s! accounting = ports authentication = ports Sets port configuration. accounting - the accounting list (optional). If none ... s! anontemplate = template simple name authtemplate = template simple name anontemplate - Specifies the name of the health ... s! answerfile = answerfile Repairs the installation of all Remote Access components. answerfile - the answerfile name. If ... s! blackout = blackout noresponse = noresponse Sets the blackout time and no response time. blackout - Specifies the time ... s! blob= Restores the Router.pbk file from netsh dump script. Do not call this command explicitly as it is to be used only ... s! component = component Shows whether tracing for the given component is enabled. If no component is specified, shows the ...