Check the library door and ensure that it is closed properly. If the door is not closed, close it and then retry this operation.
Check the following to troubleshoot this issue: 1) If the agent is not installed on %ServerName;, run DpmAgentInstaller.exe ...
Check the following: 1) If %ServerName; is protected by another DPM server, you cannot install the protection agent on it. ...
Check the following: 1) If %ServerName; is protected by another DPM server, you cannot install the protection agent on it. ...
Check the following: 1) If %ServerName; is protected by another DPM server, you cannot install the protection agent on it. ...
Check the library door and ensure that it is closed properly. If the door is not closed, close it and then retry this operation. ...
Check the parameters that you are passing to the cmdlet and ensure that these parameters correspond to the data source type ...
Check the parameters that you are passing to the cmdlet, and make sure that these parameters match the parameters that the ...
Check the SCSI and bus mappings of the drive to ensure that the drive is mapped correctly. If you change any of the mappings, ...
Check to see if some dependent data sources have been added to the protected data source %DatasourceName;. In that case run ...