The device "%hs" has detected a CardBus card in its slot, but the firmware on this system is not configured to allow the CardBus controller to be run in CardBus mode. The operating system will currently accept only 16-bit (R2) pc-cards on this controller.
The destination disk or drive may be full, or files may be locked by SHARE. Delete unwanted files, or wait until the files ...
The destination folder cannot be the root directory of the destination drive. Specify a valid folder; if it does not exist, ...
The destination folder is where the customized packages will be placed when the wizard is finished. If the folder you specify ...
The detected device is of unknown type. Be sure that: 1. The device is properly configured. 2. The address on the previous ...
The device "%hs" has detected a CardBus card in its slot, but the firmware on this system is not configured to allow the ...
The device %s is now available on your network, and can be found in the My Network Places folder on your desktop. Would you ...
The device '%s' cannot be stopped because it is using a driver that does not support Plug and Play. Since this device is ...
The Device Control Block (DCB) property contains the control settings for a serial communications device, in this case, the ...
The device could not allocate one or more required resources due to conflicts with other devices. The device DMA setting ...