IPSec user mode security association establishment failed. Keying module type: AuthIp Local address: %1 Remote address: %2 ...

Windows Server 2008

IPSec user mode security association establishment failed.
 Keying module type: AuthIp
 Local address: %1
 Remote address: %2
 Local port: %3
 Remote port: %4
 Peer private address: %5
 User mode authentication method: %6
 User mode peer subject: 
%7
 User mode peer issuing certificate authority: 
%8
 User mode peer root certificate authority: 
%9
 User mode peer SHA thumbprint: 
%10
 User mode my subject: 
%11
 User mode my SHA thumbprint: 
%12
 Failure point: %13
 Failure reason: %14
 User mode IKE state: %15
 Initiator or Responder: %16
 User mode impersonation: %17

IPsec Services failed to process some IPsec filters on a plug-and-play event for network interfaces. This poses a potential ... IPsec Services has been shut down successfully. The shutdown of IPsec Services can put the computer at greater risk of network ... IPsec Services has experienced a critical failure and has been shut down. The shutdown of IPsec Services can put the computer ... IPSec user mode security association establishment failed. Keying module type: AuthIp Local address: %1 Remote address: %2 ... IPSec user mode security association establishment failed. Keying module type: AuthIp Local address: %1 Remote address: %2 ... IPsec will be used to enforce the local interface restrictions defined for this port. Since IPsec is incompatible with dynamically ... IPsec will use these settings to establish secured connections when there are active connection security rules. When you ... IPv4 support has been disabled in WMPNetworkSvc because IP address table retrieval encountered error '%1'. To enable IPv4 ... IPv4 support has been disabled in WMPNetworkSvc because NotifyAddrChange encountered error '%1'. To enable IPv4 support, ...