UI Translation

Windows Server 2008

  1. The Message Queuing service will not join the %1 domain. An MSMQ Configuration (msmq) object exists in the new domain with ...
  2. The Message Queuing Triggers Configuration page cannot be displayed. Message Queuing Triggers may not be properly installed. ...
  3. The MessageOriented property indicates whether the protocol is message-oriented. A message-oriented protocol uses packets ...
  4. The metadata cleanup for the requested server should happen on an Active Directory Domain Controller (AD DC) in the same ...
  5. The metadata of element %1 is too large. The maximum allowed size is 2048 bytes. Reduce the size of the metadata of element ...
  6. The metadata of element %1 would cause the total published metadata to be more than 32k, which is the maximum allowable size ...
  7. The meter on the wall shows how much time you have left. You must find all matches before time runs out. You can turn off ...
  8. The method enables setting a more granular set of permissions to the existing account. The flag, Allowspecifies if Permissions ...
  9. The method failed because the session is changing its type. No IOPMVideoOutput methods can be called when a session is changing ...
  10. The Method of Reporting Informational Exceptions (MRIE) indicates the methods that shall be used by the target to report ...
  11. The metric indicates the cost of the route. In the case of RIP routes, the cost is determined by the number of routers to ...
  12. The Metric1 property contains the primary routing metric for this persisted route. The semantics of this metric are determined ...
  13. The Metric1 property contains the primary routing metric for this route. The semantics of this metric are determined by the ...
  14. The Metric2 property contains an alternate routing metric for this route. The semantics of this metric are determined by ...
  15. The Metric3 property contains an alternate routing metric for this route. The semantics of this metric are determined by ...
  16. The Metric4 property contains an alternate routing metric for this route. The semantics of this metric are determined by ...
  17. The Metric5 property contains an alternate routing metric for this route. The semantics of this metric are determined by ...
  18. The Microsoft "Route through e-mail" method is still enabled for at least one device. Disable the method for all remaining ...
  19. The Microsoft Clearinghouse server is experiencing problems. Please try this transaction later. If the problem persists, ...
  20. The Microsoft Customer Support representative will provide you with a confirmation code. Type this confirmation code in the ...
  21. The Microsoft Customer Support representative will provide you with a license key pack ID. Type this ID in the following ...
  22. The Microsoft Customer Support representative will provide you with a license server ID. Type this ID in the following boxes. ...
  23. The Microsoft Customer Support representative will provide you with a new license server ID. Type this ID in the following ...
  24. The Microsoft DHCP Server service was detected as installed but not running. If you enable the DHCP Server, please consult ...
  25. The Microsoft DHCP Server service was detected but it failed to start within the expected time period. The Windows Deployment ...
  26. The Microsoft DHCP Server was successfully configured to co-exist with the Windows Deployment Services Server. For more information ...
  27. The Microsoft Distributed Transaction Coordinator (DTC) failed. The Message Queuing service cannot continue. Please restart ...
  28. The Microsoft Exchange 5.5 server name specified in the address does not match the one specified in the Microsoft Exchange ...
  29. The Microsoft iSCSI service is not running. The service is required to be started for iSCSI to function correctly. Do you ...
  30. The Microsoft Report Viewer control is not installed on current machine. Click the following link to download and install ...
  31. The Microsoft Report Viewer control is not installed on current machine. Please download the component from http://go.mi ...
  32. The Microsoft-Windows-DiskDiagnosticResolver warns users about faults reported by hard disks that support the Self Monitoring ...
  33. The middle-tier application server can process transactions on behalf of network clients, coordinate distributed transactions, ...
  34. The MiniDumpDirectory property indicates the directory where small memory dump files will be recorded and accumulated. Example: ...
  35. The minimum size of the update sequence number (USN) journal to allocate on the volume, in megabytes. If no USN journal exists, ...
  36. The MinimumWorkingSetSize property indicates the minimum working set size of the process. The working set of a process is ...
  37. The Mobile page cannot be displayed. Message Queuing may not be properly installed. Please reinstall Message Queuing using ...
  38. The modem failed to respond. Make sure it is properly connected and turned on. If it is an internal modem or is connected, ...
  39. The modem is already in use or is not configured for Remote Access dial out. For troubleshooting information, click Help. ...
  40. The ModemInfPath property indicates the path to this modem's .inf file. This file contains initialization information for ...
  41. The ModemInfSection property indicates the name of the section in the modem's .inf file that contains information about the ...
  42. The modifiers can be combined to get compound results: %~dp1 - expands %1 to a drive letter and path only %~nx1 - expands ...
  43. The ModulationBell property contains the command string used to instruct the modem to use Bell modulations for 300 and 1200 ...
  44. The ModulationCCITT property contains the command string used to instruct the modem to use CCITT modulations for 300 and ...
  45. The module "%1" failed to load. Make sure the binary is stored at the specified path or debug it to check for problems with ...
  46. The module "%1" may not compatible with the version of Windows that you're running. Check if the module is compatible with ...
  47. The module "%1" was loaded but the call to %2 failed with error code %3. For more information about this problem, search ...
  48. The module "%1" was loaded but the entry-point %2 was not found. Make sure that "%1" is a valid DLL or OCX file and then ...
  49. The module "%1" was loaded but the entry-point %2 was not found. Make sure that "%1" is a valid DLL or OCX file and then ...
  50. The MOF file created for the %1!s! service cannot be deleted as requested. The automatic recovery function requires the MOF ...
  51. The MOF file created for the %1!s! service could not be loaded. The record data contains the error code returned by the MOF ...
  52. The MofSelfInstallDirectory property contains the directory path for applications that install MOF files to the CIM repository. ...
  53. The Monitor Configuration API only works with monitors that support the MCCS 1.0 specification, MCCS 2.0 specification or ...
  54. The Monitor Configuration API only works with monitors which support the MCCS 1.0 specification, MCCS 2.0 specification or ...
  55. The monitor displays network performance between the Windows Media Center Extender and the computer while you make changes. ...
  56. The monitor returned a DDC/CI capabilities string that did not comply with the ACCESS.bus 3.0, DDC/CI 1.1 or MCCS 2 Revision ...
  57. The monitor returned a DDC/CI capabilities string which did not comply with the ACCESS.bus 3.0, DDC/CI 1.1, or MCCS 2 Revision ...
  58. The monitor returned an invalid monitor technology type. CRT, Plasma and LCD (TFT) are examples of monitor technology types. ...
  59. The monitor you have selected is currently disabled. If you enable this monitor, then it will be used as part of your Windows ...
  60. The MonitorManufacturer property indicates the name of the manufacturer of the display device. Example: NEC This property ...
  61. The MonitorProcessId property provides the process ID of the the Resource Host Service that is currently hosting the resource. ...
  62. The MonitorType property indicates the model name of the display device. Example: NEC 5FGp This property has been deprecated ...
  63. The most appropriate broadcast standard for your region is selected. If your video is black and white or is missing audio, ...
  64. The most likely cause of this error is that the DCOM server is not registered or has been deleted. Reregister the Rrasprxy.dll ...
  65. The move table quota for Distributed Link Tracking in this domain has been exceeded. This table is used by Distributed Link ...
  66. The MoveFiles action allows the author to locate files that already exist on the user's machine, and move or copy those files ...
  67. The movie cannot be burned to the recordable CD because the CD burner speed is not fast enough to use a high-speed recordable ...
  68. The movie cannot be published to the location "%1". Verify that the address is valid and that your computer is connected ...
  69. The movie could not be published to the specified Web server because you do not have the appropriate access permissions. ...
  70. The movie file cannot be published to the specified location. Verify that the publishing location is still available, that ...
  71. The MPU401Address property indicates the starting I/O address assigned to the MPU-401 port of the sound device. Example: ...
  72. The MS DTC administrative component has failed to start. You may not have permissions to manage the remote MS DTC, MS DTC ...
  73. The MS DTC Connection Manager is unable to register with RPC to use TCP/IP or UDP/IP. Please ensure that RPC is configured ...
  74. The MS DTC log file is unreadable. After ensuring that all Resource Managers coordinated by MS DTC have no indoubt transactions, ...
  75. The MS DTC Service is terminating because it didnt startup in a timely manner. This may be because MS DTC took too long to ...
Deutsch (Deutschland)
German (Germany) Español (España)
Spanish (Spain) Français (France)
French (France) italiano
Italian 日本語
Japanese 한국어
Korean Português
Portuguese Русский
Russian English
English (United States)