UI Translation

Windows 8

  1. NLB cluster %2]: This host is configured to persist 'Suspended' after the system restarts. Because the last known state of ...
  2. NLB cluster %2]: Timer starvation has been detected. This might be due to a denial of service attack or a very high server ...
  3. NLB cluster %2]: Version mismatch between the driver and control programs. Please make sure that you are running the same ...
  4. NLB cluster on interface %1 intercepted outgoing traffic from %4 destined to %6 protocol: %7 (%9), flags: %8]. This cluster ...
  5. NLB cluster on interface %1 intercepted outgoing traffic from %4 destined to %6 protocol: %7 (%9), flags: %8]. This cluster ...
  6. NLB cluster on interface %1 intercepted outgoing traffic from %4 destined to %6. This cluster node will drop this traffic ...
  7. NLB cluster on interface %1 intercepted outgoing traffic from %4 destined to %6. This cluster node will send this traffic ...
  8. NLB cluster on interface %1 received traffic from %4 destined to %6 protocol: %7 (%9), flags: %8]. This cluster node will ...
  9. NLB cluster on interface %1 received traffic from %4 destined to %6 protocol: %7 (%9), flags: %8]. This cluster node will ...
  10. NLB cluster on interface %1 received traffic from %4 destined to %6. This cluster node will accept this traffic (reason: ...
  11. NLB cluster on interface %1 received traffic from %4 destined to %6. This cluster node will drop this traffic (reason: %2). ...
  12. NLB is already enabled on the external adapter. To configure load balancing, remove existing NLB settings for the adapter. ...
  13. NLB is already enabled on the internal adapter. To configure load balancing, remove existing NLB settings for the adapter. ...
  14. NLB is operating in pass-through mode because an error occurred during configuration. Check the system event log on the specified ...
  15. NLB Manager is connected to the host using the current dedicated IP address. Therefore the dedicated IP address can not be ...
  16. NLB Manager is connected to the host using this interface. Since this interface is currently DHCP-enabled, it cannot be used ...
  17. NLB Manager is running in demonstration mode. The following machines do not have NLB bound on any interface: NLB-A NLB-B ...
  18. NLB settings on the external adapter of the server on which you want to enable load balancing cannot be retrieved. If you ...
  19. NLB settings on the internal adapter of the server on which you want to enable load balancing cannot be retrieved. If you ...
  20. NLB: Attempt to retrieve adapter name in section '%1' of answer file failed hr (0x) = '%2!x!'. Skipping to next adapter. ...
  21. NLS codepage operation failed for the codepage %1 because the file %2 is corrupted. To correct this error, replace this file ...
  22. NLS codepage operation failed for the codepage %1 because the file %2 is missing. To correct this error, replace this file ...
  23. NLS operation failed for %1 locale because the file %2\globalization\%1.nlp is corrupted. To fix this problem, reinstall ...
  24. NLS operation failed for %1 locale because the file %2\globalization\%1.nlp is missing. To fix this problem, reinstall this ...
  25. No applicable main package was found for this platform. The directory must contain an applicable package with a .main file ...
  26. No authorization rules match the given parameters, but one or more rules were ignored due to errors; see previous warnings ...
  27. No available tuner is able to tune to the requested channel. If you are using a set-top box, make sure the IR control cable ...
  28. No backup can be performed on this server. Current Group Policy settings prevent backing up to remote shared folders, local ...
  29. No backup has been configured for this computer. Use the Backup Schedule Wizard or the Backup Once Wizard to perform a regular ...
  30. No BitLocker Drive Encryption Data Recovery Agents have been defined in any group or local policy that was evaluated to produce ...
  31. No BitLocker Drive Encryption Network Unlock Certificate has been defined in any group or local policy that was evaluated ...
  32. No CA servers can be detected, and OTP cannot be configured. Ensure that servers added to the list are available on each ...
  33. No CA's listed in the domain. The configuration might be stored in the root domain. Use the -dc option to target your root ...
  34. No certificate templates are available in Active Directory. At least one certificate template is required to create an automatic ...
  35. No certificate templates can be detected. To configure OTP, at least one template must be configured for enrollment on the ...
  36. No certificate templates could be found. You do not have permission to request a certificate from this CA, or an error occurred ...
  37. No certificate templates in the forest are configured to be sent as part of the policy response. Confirm that the server ...
  38. No certification authorities were found in your domain. You can install CA on the local computer, or select a CA later using ...
  39. No changes in the extensions for this resource type were detected. This may indicate a failure to register the extension ...
  40. No changes were made during this call, but the sink wants another chance to look if any other sinks make further changes. ...
  41. No changes were made to the host because no parameters were specified. To make changes to the host, run Set-VMHost with one ...
  42. No channels are available in the Guide. Select Set Up to reconfigure the Guide. If the problem persists, contact your hardware ...
  43. No command proxies have been created, because all of the requested remote commands would shadow existing local commands. ...
  44. No compatible Trusted Platform Module (TPM) is found on this computer. Only a compatible TPM can be initialized using this ...
  45. No computer names or connection Uris were specified. You must provide a computer name or connection Uri when invoking a command ...
  46. No context is associated with this call. This happens for some custom marshalled calls and on the client side of the call. ...
  47. No controllers are associated with this LUN. Note: LUNs are associated with controller ports rather than with controllers ...
  48. No current validation report was found for this cluster. Any previous validation reports are no longer current if nodes were ...
  49. No custom object was returned for module '{0}' because the -AsCustomObject parameter can only be used with script modules. ...
  50. No Data Protection policies have been defined in any group or local policy that was evaluated to produce this resultant set ...
  51. No dedicated IP addresses were configured. This will prevent outgoing connections from being established on this interface. ...
  52. No default profile is associated with this scanner. Please select settings for scanning the document, or create a default ...
  53. No DHCP clients are being served, as the Allow list is empty and the server was configured to provide DHCP services, to clients ...
  54. No DHCP clients are being served, as the Allow list is empty and the server was configured to provide DHCP services, to clients ...
  55. No disk that can be used for recovering the system disk can be found. Try the following: 1) A probable system disk may have ...
  56. No disks are available for use as a backup storage destination. This can happen when all disks attached to the computer contain ...
  57. No disks suitable for cluster disks were found. For diagnostic information about disks available to the cluster, use the ...
  58. No DISM options were specified on the command-line. Run DISM with a command-line option specified, such as /Image or /Online. ...
  59. No documents were accessed because no e-mail address is specified in the content index server properties. Specify the e-mail ...
  60. No driver packages were found on the specified path. Verify that the driver .INF files are in the specified location and ...
  61. No duplicate SPNs found for trusted services. Duplicate SPNs may exist for other accounts. Use Setspn.exe to query forests ...
  62. No DWM redirection surface is available} The DWM was unable to provide a redireciton surface to complete the DirectX present. ...
  63. No Encrypting File System policies have been defined in any group or local policy that was evaluated to produce this resultant ...
  64. No events are available. This computer is reporting detailed events to {0}. To see detailed events for this computer, please ...
  65. No events are available. This may be because the client has not yet sent the event or the events have been purged from the ...
  66. No feature or operating system setting has been specified for import. You must first specify features or operating system ...
  67. No folders in the namespace can be moved because one or more folders in the namespace were created by a server running Windows ...
  68. No folders in the namespace can be renamed because one or more folders in the namespace was created by a server running Windows ...
  69. No Frequency type has been specified for this job trigger. One of the following job trigger frequencies must be specified: ...
  70. No Generation ID change has been detected. Generation ID cached in DS (old value): %1 Generation ID currently in VM (new ...
  71. No Group Policy Object (GPO) updates needed, or GPO information has already been updated. Status/Consequence Adprep did not ...
  72. No handler exists to handle the message for the virtualization infrastructure driver. Restarting the virtual machine may ...
  73. No help topic could be found for the %1 option. Specify an image to see relevant help topics, using either the /Image or ...
  74. No information was found in the relevant documents with the specified properties, because a clause of the query contained ...
  75. No IPv6 address is configured on the remote computer running the network location server. DirectAccess client computers on ...
Deutsch (Deutschland)
German (Germany) Español (España)
Spanish (Spain) Français (France)
French (France) italiano
Italian 日本語
Japanese 한국어
Korean Português
Portuguese Русский
Russian English
English (United States)