%1!s! [ name = ] name [ [ state = ] ENABLE|DISABLE [ processingorder = ] processingorder [ policysource = ] policysource [ conditionid = ] conditionid [ conditiondata = ] conditiondata [ profileid = ] profileid [ profiledata = ] profiledata ] Sets connection request policy configuration. name - the name (required). state - the state (optional). ENABLE - enabled (default). DISABLE - disabled. processingorder - the processing order (optional). policysource - the policy source (optional). 0 - Unspecified(default). 1 - Terminal Server Gateway. 2 - Remote Access Server(VPN-Dial up). 3 - DHCP Server. 5 - Health Registration Authority. 6 - HCAP. conditionid - the condition id (optional). conditiondata - the condition data (optional). profileid - the profile id (optional). profiledata - the profile data (optional). Usage of IP Filters: profileid = advprofiletype = "" advprofiledata = "" Each profileid can be followed by multiple pairs of advprofiletype and advprofiledata. The following are supported: Name ID ----------------------------------------------------------- MS-Quarantine-IPFilter 0x1045 MS-Filter 0x102f MS-IPv6-Filter 0x1fd0 For , the following are supported: Name profileType ----------------------------------------------------------- IPv4 Input filters IPFILTER_IPV4INFILTER IPv4 Output filters IPFILTER_IPV4OUTFILTER IPv6 Input filters IPFILTER_IPV6INFILTER IPv6 Output filters IPFILTER_IPV6OUTFILTER For advprofiledata, the format of is: ,,,,, Required. Specifies whether IP traffic is permitted or denied: PERMIT - Specifies that all IP traffic is permitted except for the packets that you designate with the ,,, and parameters in this command. DENY - Specifies that all IP traffic is denied except for the packets that you designate with the ,,, and parameters in this command. Required. Specifies either an IPv4 or an IPv6 address Required. Specifies the IPv4 subnet mask or the IPv6 prefix length: "x.x.x.x" - Specifies an IPv4 subnet mask. - Specifies an IPv6 prefix length. Optional. Specifies the protocol number as an integer, such as 6 for TCP or 17 for UDP. and Optional. Specifies the source port and destination port as integers. If specified, you must designate both a source port and a destination port. If you do not specify a source port and destination port, all IP traffic to the specified IP address will be permitted or denied based on the value of . Example: %1!s! name = "Use Windows authentication for all users" state = "ENABLE" processingorder = "1" policysource = "0" conditionid = "0x1006" conditiondata = "0 00:00-24:00; 1 00:00-24:00" profileid = "0x1025" profiledata = "0x1" profileid = "0x1045" advprofiletype = "IPFILTER_IPV4INFILTER" advprofiledata = "PERMIT,123.123.123.0,255.255.255.0,0, 0,0"