Specifies the hours that Windows will use to determine how long to wait before checking for available updates. The exact ...

Windows 10

Specifies the hours that Windows will use to determine how long to wait before checking for available updates. The exact wait time is determined by using the hours specified here minus zero to twenty percent of the hours specified. For example, if this policy is used to specify a 20 hour detection frequency, then all clients to which this policy is applied will check for updates anywhere between 16 and 20 hours.

If the status is set to Enabled, Windows will check for available updates at the specified interval.

If the status is set to Disabled or Not Configured, Windows will check for available updates at the default interval of 22 hours.

Note: The "Specify intranet Microsoft update service location" setting must be enabled for this policy to have effect.

Note: If the "Configure Automatic Updates" policy is disabled, this policy has no effect.

Note: This policy is not supported on Windows RT. Setting this policy will not have any effect on Windows RT PCs.

Specifies the Dynamic Bandwidth Allocation (DBA) algorithm used for calculating the average line utilization (ALU) for transmitted ... Specifies the e-mail address to be used when sending the log files that are generated by NCA to the network administrator. ... Specifies the earliest time at which the printer will print a job, expressed as minutes elapsed since 12:00 AM GMT (Greenwich ... Specifies the encoding of Extensible Authentication Protocol (EAP) information to allow dial-in users to use EAP to authenticate ... Specifies the hours that Windows will use to determine how long to wait before checking for available updates. The exact ... Specifies the interval used by DNS clients to refresh registration of A and PTR resource. This policy setting only applies ... Specifies the IP traffic filter that is used by the Routing and Remote Access service when the connection is in a restricted ... Specifies the largest Job (as a byte stream) that the Printer will accept in units of Kbytes. A value of zero indicates that ... Specifies the latest time at which the printer will print a job, expressed as minutes elapsed since 12:00 AM GMT (Greenwich ...