Specify a volume that exists on the source machine %ServerName;. If the configuration of the source machine changed, gather system information again by restarting the Convert Physical Server wizard.
Specify a value for the missing parameter -SourceNetworkConnectionID or remove any of the VirtualNetworkAdapter parameters ...
Specify a value for the missing parameter -VolumeDeviceID or remove -DiskSizeAdd parameter, and then try the operation again. ...
Specify a value for the missing parameter -VolumeDeviceID or remove -Fixed or -Dynamic parameter, and then try the operation ...
Specify a value for the missing parameter -VolumeDeviceID or supply the -Trigger parameter to start operation of the JobGroup ...
Specify a volume that exists on the source machine %ServerName;. If the configuration of the source machine changed, gather ...
Specify all necessary parameters including protocol and load balancing method, or provide a virtual IP (VIP) address template. ...
Specify an additional virtual hard disk that is not attached to any other virtual machine, and then try the operation again. ...
Specify an end address for the range that is greater or equal than the start address. 2. Ensure that the address range is ...
Specify an end address for the range that is greater or equal than the start address. 2. Ensure that the first three octets ...