Node {0} has an IPv4 address {1} configured as Automatic Private IP Address (APIPA) for adapter {2}. This adapter will not ...

Node {0} has an IPv4 address {1} configured as Automatic Private IP Address (APIPA) for adapter {2}.  This adapter will not be added to the Windows Failover Cluster.  If the adapter is to be used by Windows Failover Cluster, the IPv4 properties of the adapter should be changed to allow assignment of a valid IP address that is not in the APIPA range.   APIPA uses the range of 169.254.0.1 thru 169.245.255.254 with subnet mask of 255.255.0.0.

Node '%1' failed to join the cluster because it could not send and receive failure detection network messages with other ... Node '%1' formed a failover cluster without performing a version compatibility check because version compatibility checking ... Node '%1' successfully became part of a failover cluster and detected that its cluster service software has been updated. ... Node '{0}' could not be initialized for validation testing. Possible causes for this are another validation test is being ... Node {0} has an IPv4 address {1} configured as Automatic Private IP Address (APIPA) for adapter {2}. This adapter will not ... Node {0} is not reachable from node {1}. It is necessary that each cluster node can communicate each other cluster node by ... Node {0} is reachable from Node {1} by multiple communication paths, but each path includes network interface {2}. This network ... Node {0} is reachable from Node {1} by only one pair of interfaces. It is possible that this network path is a single point ... Nodes are not consistently configured with IPv4 and/or IPv6 addresses on network adapters that are usable by the cluster. ...