The DDE command ShowGroup does not operate synchronously, though it should. Often the application will resume before the group is visible, not a problem in and of itself, but this creates problems if the application calls DeleteGroup before the group is visible. In that case, Explorer will generate this lengthy message: "DirName refers to a location that is unavailable. It could be on a hard drive on this computer, on a network, or on a different computer on your home network. Check to make sure that the disk is properly inserted, or that you are connected to the Internet or home network, and then try again. If it still cannot be located, the information may have been moved to a different location."
The DaysOfMonth parameter indicates the days of the month when the job is scheduled to run, and is used only when the RunRepeatedly ...
The DaysOfWeek parameter indicates the days of the week when the job is scheduled to run, and is used only when the RunRepeatedly ...
The DCOMLAUNCH service launches COM and DCOM servers in response to object activation requests. If this service is stopped ...
The DcSiteName property indicates the name of the site where the domain controller is located. This value may be NULL if ...
The DDE command ShowGroup does not operate synchronously, though it should. Often the application will resume before the ...
The DDE command ShowGroup does not operate synchronously, though it should. Often the application will resume before the ...
The DDS image format isn't supported in Internet Explorer on Windows 7. Get more info at http://go.microsoft.com/fwlink/?LinkId=291257 ...
The DeadGWDetectEnabled parameter specifies a value that can enable the TCP to perform dead gateway detection. If TRUE, the ...
The DeadGWDetectEnabled property indicates whether dead gateway detection occurs. Setting this parameter to TRUE causes TCP ...