Displays and modifies the IP-to-Physical address translation tables used by address resolution protocol (ARP). ARP -s inet_addr eth_addr [if_addr] ARP -d inet_addr [if_addr] ARP -a [inet_addr] [-N if_addr] [-v] -a Displays current ARP entries by interrogating the current protocol data. If inet_addr is specified, the IP and Physical addresses for only the specified computer are displayed. If more than one network interface uses ARP, entries for each ARP table are displayed. -g Same as -a. -v Displays current ARP entries in verbose mode. All invalid entries and entries on the loop-back interface will be shown. inet_addr Specifies an internet address. -N if_addr Displays the ARP entries for the network interface specified by if_addr. -d Deletes the host specified by inet_addr. inet_addr may be wildcarded with * to delete all hosts. -s Adds the host and associates the Internet address inet_addr with the Physical address eth_addr. The Physical address is given as 6 hexadecimal bytes separated by hyphens. The entry is permanent. eth_addr Specifies a physical address. if_addr If present, this specifies the Internet address of the interface whose address translation table should be modified. If not present, the first applicable interface will be used. Example: > arp -s 157.55.85.212 00-aa-00-62-c6-09 .... Adds a static entry. > arp -a .... Displays the arp table.
Displays a list of files and subdirectories in a directory. DIR drive:][path][filename /A[:]attributes /B /C /D /L /N /O[:]sortorder ...
Displays a list of partitions in the partition table for the selected disk. Syntax: LIST PARTITION On dynamic disks, the ...
Displays a list of replication failures that Knowledge Consistency Checker (KCC) is aware of. Run this command from the console ...
Displays a list of the available commands or detailed help information for a specified command. Syntax: HELP The command ...
Displays and modifies the IP-to-Physical address translation tables used by address resolution protocol (ARP). ARP -s inet_addr ...
Displays event log configuration information, including whether the log is enabled, the current maximum size limit of the ...
Displays inbound replication requests that the DC needs to issue to become consistent with its source replication partners. ...
Displays information about a user on a specified system running the Finger service. Output varies based on the remote system. ...
Displays information about the current file system for the selected volume, and the supported file systems for formatting ...