1. Specify an end address for the range that is greater or equal than the start address. 2. Ensure that the first three octets of the start address and the end address for the range are equal.
Specify a volume that exists on the source machine %ServerName;. If the configuration of the source machine changed, gather ...
Specify all necessary parameters including protocol and load balancing method, or provide a virtual IP (VIP) address template. ...
Specify an additional virtual hard disk that is not attached to any other virtual machine, and then try the operation again. ...
Specify an end address for the range that is greater or equal than the start address. 2. Ensure that the address range is ...
Specify an end address for the range that is greater or equal than the start address. 2. Ensure that the first three octets ...
Specify an IP pool with available virtual IP addresses or a host group with appropriate virtual IP addresses availability ...
Specify an IPv4 address or IPv4 address pool using Set-SCVirtualNetworkAdapterConfiguration, or configure the virtual network ...
Specify an IPv6 address or IPv6 address pool using Set-SCVirtualNetworkAdapterConfiguration, or configure the virtual network ...
Specify an operating system for which customization is supported, or use the -NoCustomization parameter, and try the operation ...