SetPowerState defines the desired power state for a LogicalDevice and when a Device should be put into that state. The desired ...

SetPowerState defines the desired power state for a LogicalDevice and when a Device should be put into that state. The desired power state is specified by setting the PowerState parameter to one of the following integer values: 1=\"Full Power\", 2=\"Power Save - Low Power Mode\", 3=\"Power Save - Standby\", 4=\"Power Save - Other\", 5=\"Power Cycle\" or 6=\"Power Off\". The Time parameter (for all state changes but 5, \"Power Cycle\") indicates when the power state should be set, either as a regular date-time value or as an interval value (where the interval begins when the method invocation is received). When the PowerState parameter is equal to 5, \"Power Cycle\", the Time parameter indicates when the Device should power on again. Power off is immediate. SetPowerState should return 0 if successful, 1 if the specified PowerState and Time request is not supported, and some other value if any other error occurred. In a subclass, the set of possible return codes could be specified, using a ValueMap qualifier on the method. The strings to which the ValueMap contents are 'translated' may also be specified in the subclass as a Values array qualifier.

Set-ADForestMode has failed to change the forest functional level to '{1}'. If raising the level, please ensure that all ... SETLOG Commands Supported - growth Change the automatic growth settings maxextents Change the maximum number of containers ... SetMonitorColorTemperature()'s caller passed a color temperature to it which the current monitor did not support. This error ... SetPowerState defines the desired power state for a logical device and when a device should be put into that state. The desired ... SetPowerState defines the desired power state for a LogicalDevice and when a Device should be put into that state. The desired ... SetPowerState defines the desired power state of a ComputerSystem and its running OperatingSystem, and when the system should ... SetPowerState method defines the desired power state of a computer system and its running operating system, and when the ... Sets Configuration Information. 1. wsrmc /Set:Config /Acc /i: should be in valid XML format. 2. wsrmc /Set:Config /Acc /dbpath: ... Sets non-%MICROSOFT_COMPANYNAME% programs (when available) as defaults, and enables or removes access to the programs shown ...