Adapter %2 : The adapter failed to initialise. Please run Madge Assist to try and identify any hardware problems. If this is not successful please report this error and the three DWORDs at the end of the data section below to Madge Technical Support.
Adapter %2 : PCI resources could not be allocated for the PCI adapter at the PCI Device ID specified. The last DWORD in the ...
Adapter %2 : The adapter could not open onto the ring. Please ensure that the lobe cable is properly attached, that any LAA ...
Adapter %2 : The adapter could not open onto the ring. Please ensure that the lobe cable is properly attached, that any LAA ...
Adapter %2 : The adapter failed to initialise. Please run Compaq CPQSETMT to try and identify any hardware problems. If this ...
Adapter %2 : The adapter failed to initialise. Please run Madge Assist to try and identify any hardware problems. If this ...
Adapter %2 : The adapter has attempted a FailOver switch but the slave adapter failed to start. Check that the slave adapter ...
Adapter %2 : The adapter has attempted a mirror switch but the slave adapter failed to start. Check that the slave adapter ...
Adapter %2 : The adapter has not been properly configured. If it is an EISA adapter please run the EISA configuration utility. ...
Adapter %2 : The adapter was unable to map the shared memory required to successfully initialize. This usually occurs because ...