No protection group has been created.
Before you start protecting data, DPM recommends that you do the following:
1. Add disks to the DPM storage pool, unless you want to use custom volumes.
2. Install a protection agent on each computer that you want to protect.
3. Install a tape library if you want to use tape-based protection.
4. Sign up for {0} and register this DPM Server for Online Protection if you want to use online protection.
NET installation has failed. Run dotNetFX35setup.exe from \Redist\DotNetFrameworks to install .NET and launch DPM setup again. ...
No action is required because DPM will update its virtual machine configuration and then automatically trigger a new backup ...
No DPM Online recovery point was created, because synchronization between DPM server and DPM Online has not occurred since ...
No protection group has been created. Before you start protecting data, DPM recommends that you do the following: 1. Add ...
No protection group has been created. Before you start protecting data, DPM recommends that you do the following: 1. Add ...
No recoverable items available. You need to create a Protection Group before you can start recovering. Please see Protection ...
No recovery point was created, either because synchronization has not occurred since the last recovery point was created, ...
No recovery points available for items below as they are not part of any Protection Group. However, data inside them which ...
No VSS provider supports one or more volumes for data source %DatasourceName; on %ServerName;, therefore DPM cannot create ...