IPv4 support has been disabled in WMPNetworkSvc because NotifyAddrChange encountered error '%1'. To enable IPv4 support, restart the WMPNetworkSvc service.
IPSec user mode security association establishment failed. Keying module type: AuthIp Local address: %1 Remote address: %2 ...
IPsec will be used to enforce the local interface restrictions defined for this port. Since IPsec is incompatible with dynamically ...
IPsec will use these settings to establish secured connections when there are active connection security rules. When you ...
IPv4 support has been disabled in WMPNetworkSvc because IP address table retrieval encountered error '%1'. To enable IPv4 ...
IPv4 support has been disabled in WMPNetworkSvc because NotifyAddrChange encountered error '%1'. To enable IPv4 support, ...
IPv6 Host (AAAA) Host address (AAAA) record for IPv6 hosts. Maps a DNS domain name to a single 128-bit IPv6 address. (RFC ...
IPv6 Tunnel address resource '%1' failed to come online because it does not depend on an IP Address (IPv4) resource. Dependency ...
IPv6 tunnel address resource '%1' failed to come online. Cluster network '%2' associated with dependent IP address (IPv4) ...
IPX is not installed or is disabled for Routing and Remote Access. You can install/enable IPX by viewing the properties of ...