IPsec will be used to enforce the local interface restrictions defined for this port. Since IPsec is incompatible with dynamically assigned addresses, the DHCP assigned addresses must be explicitly reserved for the server. If not, you must convert to static IP addresses, remove the remote address restrictions, or remove the local interface restrictions. Do you want to fix the problem now by changing the port restrictions?
IPSec received inbound clear text packet that should have been secured: Packet Source: %1 Inbound SA: %2 Number of Packets: ...
IPSec Services failed to get the complete list of network interfaces on the machine. This can be a potential security hazard ...
IPSec Services failed to process some IPSec filters on a plug-and-play event for network interfaces. This is a security hazard ...
IPSec Services has experienced a critical failure and has shut down with error code: %1. Stopped IPSec Services can be a ...
IPsec will be used to enforce the local interface restrictions defined for this port. Since IPsec is incompatible with dynamically ...
IPv6 Host (AAAA) Host address (AAAA) record for IPv6 hosts. Maps a DNS domain name to a single 128-bit IPv6 address. (RFC ...
IPX is not installed or is disabled for Routing and Remote Access. You can install/enable IPX by viewing the properties of ...
IRQ trigger level indicating whether the interrupt is triggered by the hardware signal going high (value=4) or low (value=3). ...
IRQ trigger type indicating whether edge (value=4) or level triggered (value=3) interrupts occur. Also, \"Other\" (1) and ...