Windows 7

  1. This resource generates a new checkpoint when it is created. During migration the new checkpoint was replaced with the checkpoint ...
  2. This resource has a dependency configuration that does not include a Network Name and Physical Disk resource. This resource ...
  3. This resource has a dependency configured that makes it is dependent on another resource. This resource type is usually not ...
  4. This resource is configured to run in a separate monitor. By default, resources are configured to run in a shared monitor. ...
  5. This resource is marked with a state of 'Failed' instead of 'Online'. This failed state indicates that the resource had a ...
  6. This resource is marked with a state of 'Offline'. The functionality that this resource provides is not available while it ...
  7. This resource is not configured to use the standard 'Pending timeout' value for the resource type. 'Pending timeout' specifies ...
  8. This resource is not configured to use the standard health check interval for the resource type. A health check is a periodic ...
  9. This resource requires dependencies on instances of the following resource types or classes: {0}. Not adding these dependencies ...
  10. This resource setting cannot be modified in this configuration. Try choosing a different configuration in the 'Settings Based ...
  11. This ResultNode instance already exists in a collection. To add it to this collection, first remove it from the other collection. ...
  12. This revocation configuration is either not yet applied to the OCSP Service or OCSP Service encountered some problem while ...
  13. This revocation provider determines the revocation status of certificates based on CRLs issued by the CA. Identify the locations ...
  14. This root certificate appears to be trusted by the remote computer. To ensure this root certificate is valid on the remote ...
  15. This router is currently configured for LAN routing only. Enable demand-dial by reinstalling before adding demand-dial interfaces. ...
  16. This routing link connects a foreign site to a non-foreign site. In order for the link to function properly, you must define ...
  17. This routing link connects a foreign site to a non-foreign site. In order for the link to function properly, you must define ...
  18. This rule currently has the following properties defined that are not supported through this interface: {0} If you continue, ...
  19. This scope is currently active. Disabling the scope will prevent clients from obtaining IP addresses. Are you sure you want ...
  20. This screen saver can't run because it requires functionality that is not available on your hardware-accelerated video card. ...
  21. This security catalog cannot be verified. The certificate that counter-signed this security catalog is not available for ...
  22. This security catalog cannot be verified. The certificate that signed this security catalog is not available for verification. ...
  23. This security catalog is not valid. The countersignature cannot be verified, and the security catalog may have been altered. ...
  24. This security policy contains data to configure services and network security based on the server's role, as well as data ...
  25. This security policy is not valid or using a file format that is no longer supported. Recreate the policy using the current ...
  26. This security policy might be applied to servers with services not specified by the policy. When an unspecified service is ...
  27. This security-sensitive option means that services running as localsystem on this computer can request services from other ...
  28. This serial port is not enabled for use in a direct connection to another computer. It will be enabled after you complete ...
  29. This server can be authoritative for forward and reverse lookup zones. It can be configured to perform recursive resolution, ...
  30. This server can use the following Point-to-Point Protocol (PPP) options. Remote access policies determine which settings ...
  31. This server cannot join the desired Active Directory Rights Management Services (AD RMS) cluster because the AD RMS version ...
  32. This server could not be located on the network. This might be due to one or several of these reasons: a) The target server ...
  33. This server does not have the Distributed File System service running. Do you want to set the service start state to Automatic ...
  34. This server has already been configured using the Routing and Remote Access Server Setup Wizard. To make changes to the current ...
  35. This server has been configured to log requests to one log file per server. Go to the server level to edit this configuration. ...
  36. This server has not been set up for routing. In the Routing and Remote Access console, right-click the server name, and select ...
  37. This server identifies itself to callers before the connection is completed. Select the certificate that you want it to use ...
  38. This server is also a DNS server and contains Active Directory integrated zones. These zones will be deleted during the removal ...
  39. This server is an Active Directory domain controller and requires DNS for computers joined to this domain to locate it. All ...
  40. This server is an active node in a failover cluster. Uninstalling the Failover Clustering feature on this node may impact ...
  41. This server is authoritative for the DNS names of local resources but forwards all other queries to an ISP or other DNS servers. ...
  42. This server is configured in the default Remote Desktop mode for remote administration, which allows a maximum of two simultaneous ...
  43. This server is not configured to require administrator approval for unknown computers. Once this setting is enabled, you ...
  44. This server is not configured. To configure this server, first verify that you are a local administrator. Then right-click ...
  45. This server is not yet running as a domain controller. Run the Active Directory Domain Services Installation Wizard (dcpromo.exe). ...
  46. This server is the owner of the following FSMO role, but does not consider it valid. For the partition which contains the ...
  47. This server is the owner of the following FSMO role, but does not consider it valid. For the partition which contains the ...
  48. This server may not be registered in a domain for which this operation is supported. Alternatively, you may not have permissions ...
  49. This server must be restarted to finish the installation process. You cannot add or remove other roles, role services, or ...
  50. This server must be restarted to finish the removal process. You cannot add or remove other roles, role services, or features ...
  51. This server was unable to find the minimum specified number of connections to Active Directory Domain Services (AD DS) global ...
  52. This server was unable to resolve the IP addresses of other routing servers. Please check that all computers are registered ...
  53. This service caused a delay during hybrid-sleep: File Name : %3 Friendly Name : %5 Version : %7 Total Time : %8ms Degradation ...
  54. This service caused a delay in the system shutdown process: File Name : %3 Friendly Name : %5 Version : %7 Total Time : %8ms ...
  55. This service delivers network notifications (e.g. interface addition/deleting etc) to user mode clients. Stopping this service ...
  56. This service enforces legacy IPsec policies created through the IP Security Policies snap-in or the command-line tool "netsh ...
  57. This service implements the hypertext transfer protocol (HTTP). If this service is disabled, any services that explicitly ...
  58. This service is a stub for Windows Parental Control functionality that existed in Vista. It is provided for backward compatibility ...
  59. This service is responsible for loading and unloading user profiles. If this service is stopped or disabled, users will no ...
  60. This service manages events and event logs. It supports logging events, querying events, subscribing to events, archiving ...
  61. This service manages mobile broadband (GSM CDMA) data card/embedded module adapters and connections by auto-configuring the ...
  62. This service manages persistent subscriptions to events from remote sources that support WS-Management protocol. This includes ...
  63. This service or application contains one or more Client Access Points. Deleting them will not remove associated data from ...
  64. This service or application contains one or more Client Access Points. Deleting them will remove all associated data from ...
  65. This service performs IEEE 802.1X authentication on Ethernet interfaces. The Wired AutoConfig (dot3svc) Service is responsible ...
  66. This service performs networking tasks associated with configuration and maintenance in homegroups. In order to view the ...
  67. This service profile installs an L2TP/IPsec connection that requires a preshared key. Your current system configuration does ...
  68. This service profile installs an L2TP/IPsec connection that requires a preshared key. Your current system configuration does ...
  69. This service provides a Web Service interface to instances of the directory service (AD DS and AD LDS) that are running locally ...
  70. This service provides support for the Program Compatibility Assistant (PCA). PCA monitors programs installed and run by the ...
  71. This service provides support for viewing, sending and deletion of system-level problem reports for the Problem Reports and ...
  72. This service publishes a machine name using the Peer Name Resolution Protocol. Configuration is managed via the netsh context ...
  73. This service publishes a machine name using the Peer Name Resolution Protocol. Configuration is managed via the netsh context ...
  74. This service runs in the same process as the service control manager. Therefore, the service control manager cannot take ...
  75. This setting adds the Administrator security group to the roaming user profile share. Once an administrator has configured ...